VEHICLE EXTERIOR
does not work properly, use the key to lock or
unlock entrance or compartment doors.
Keyless Operating Instructions
1. To unlock the entrance door, enter the five
digits of the code. After pressing the fifth
digit, the door will unlock. During the night,
press any button to illuminate the keyboard,
then enter the code.
2. When pressing any button, the keyboard
lights up for five seconds and the step lights
illuminate for twenty-five seconds.
3. To unlock the baggage and service
compartment doors, press button 3|4 within
five seconds of entering the code.
4. To lock entrance door and compartments all
at the same time, press buttons 7|8 and 9|0
at the same time.
Programming Your Personal Code
Note: To avoid erasing your personal code from
the system memory, you should connect the
keyless entry system to house batteries,
otherwise the code will be erased each time
battery main disconnect switches are set to the
OFF position.
You can program a personal code to unlock the
entrance door and compartments. This code
does not replace the permanent code that is
programmed into the system. Use your personal
code in the same manner that you would use the
original code.
Do not choose a code that presents the
numbers in sequential order, such as 1|2, 3|4,
5|6, 7|8, 9|0. Studies show that people who idly
press the buttons usually press a sequential
pattern. Also, do not select a code that uses the
same button five times. Thieves can easily figure
out these types of codes.
1. Choose and memorize your personal code.
2. Enter the original code, and within five
seconds, press button 1|2.
3. Within five seconds of pressing button 1|2,
enter your personal code, pressing each
button within five seconds of the previous
digit. The keyboard light will immediately
turn OFF if the code is correctly entered.
The keyless entry system registers your
personal code. To unlock the entrance door,
you can use either code.
To erase your personal code, enter the original
code, press button 1|2, then wait six seconds.
Refer to chapter 3, “Controls and instruments”
for instructions on remote unlock key fob. Refer
to chapter 4, “Other Features” for full details
keyless entry system.
REAR VIEW MIRRORS
The vehicle is equipped with flat-type and
convex-type rear-view mirrors. Convex mirrors
give a wide angle view. Objects viewed in
convex-type rear-view mirrors appear smaller
and are actually closer than they appear.
REAR VIEW MIRRORS 18376
To provide good visibility in cold weather, the
mirrors are equipped with heating elements. The
elements are activated by a rocker switch
located on the dashboard. Refer to "Controls &
Instruments" chapter. Thermostats are used to
prevent continuous operation of the heating
elements.
Caution: Do not attach stick-on type convex
mirror accessories to the heated mirror glass.
This could impede uniform heat distribution on
the mirror surface and could break the mirror
glass.
The mirrors are adjusted using the controls
located on the L.H. control panel. Refer to
"Controls & Instruments" chapter. Manual
adjustment is also possible.
Adjust the side-view mirrors until the side of the
vehicle is visible. Adjust the flat-type mirror until
the road behind is in full view.
1-11
To Next Page
Loading...
Need help?
General
