OTHER FEATURES
Caution: To avoid running down the batteries,
do not turn on the preheating system for more
than one hour before starting the engine.
Warning: The preheating system uses the
same fuel as the engine. Do not operate in a
building or while refueling. Operate only in a
well-ventilated area.
110-120 VOLT CONNECTOR
110-120 VOLT POWER CONNECTOR 06390
The optional 110-120 volt power connector is
located inside the engine compartment near the
right door hinge. Refer to "Vehicle Exterior"
chapter 1. Connect the female end of an
extension cord to the male connector. Connect
the plug at the other end of the cord to a 110-
120 VAC outlet only.
The engine may be equipped with an engine
immersion-type electric block heater to assist
cold weather starting.
The engine block heater should be used
whenever the vehicle is parked for extended
periods in cold weather and whenever a suitable
power source is available.
Caution: Only use a 110-120 VAC power
source. Use only a grounded type (three
pronged) extension cord with a minimum rated
current capacity of 15 amps. Disconnect the
extension cord before starting or moving the
vehicle.
KEYLESS ENTRY SYSTEM
By using this system, you can lock or unlock the
entrance door and the baggage and service
compartment doors. The keyboard is located
below the entrance door handle. The master
code in the microprocessor/relay module is pre-
programmed by the manufacturer and cannot be
deleted. Moreover, you can program your own
entry code (e.g. a birthday or part of a social
security number).
The master code is:
• Printed on the owner's wallet card;
• Printed on three decals, joined to the
owner's wallet card.
• Printed on decal affixed to the keyless
system microprocessor/relay module in the
front console;
When you use the keyless entry system, the
keyboard and step lights illuminate.
Do not push the buttons with a key, pencil or any
other hard or sharp object as the buttons could
be damaged. Although each button is provided
with two digits separated by a vertical line, there
is only one contact per button. Press in the
center of the button (between the two digits, on
the vertical line).
You must unlock the entrance door before you
unlock any other baggage or service
compartment door. If you let more than five
seconds pass between the numbers you press,
the system shuts down, and you have to enter
your code again. If the keyless entry system
does not work properly, use the key to lock or
unlock entrance or compartment doors.
KEYLESS OPERATING INSTRUCTIONS
1. To unlock the entrance door and disarm the
anti-theft alarm, enter the permanent factory
code or the personal code. After pressing
the fifth digit, the door will unlock. During the
night, press any button to illuminate the
keyboard, then enter the code.
2. When pressing any button, the keyboard
lights up for five seconds and the step lights
illuminate for twenty-five seconds.
3. To unlock the baggage and service
compartment doors, press button 3|4 within
five seconds of entering the code.
4. To lock entrance door, compartments and
arm the anti-theft alarm system all at the
same time, press buttons 7|8 and 9|0
simultaneously.
4-16
To Next Page
Loading...
Need help?
General
