OTHER FEATURES
PROGRAMMING A PERSONAL CODE
Note: To avoid erasing your personal code from
the system memory, you should connect the
keyless entry system to house batteries,
otherwise the code will be erased each time
battery main disconnect switches are set to the
OFF position.
You can program one personal code to unlock
the entrance door and compartments. This code
does not replace the permanent code that is
factory programmed into the system. Use your
personal code in the same manner that you
would use the original code.
Do not choose a code that presents the numbers
in sequential order, such as 1|2, 3|4, 5|6, 7|8,
9|0. Studies show that people who idly press the
buttons usually press a sequential pattern. Also,
do not select a code that uses the same button
five times. Thieves can easily figure out these
types of codes.
1. Choose and memorize your personal code.
2. Enter the original code, and within five
seconds, press button 1|2.
3. Within five seconds of pressing button 1|2,
enter your personal code, pressing each
button within five seconds of the previous
digit. The keyboard light will immediately turn
OFF if the code is correctly entered.
The keyless entry system registers your personal
code. To unlock the entrance door, you can use
either code.
To erase your personal code, enter the original
code, press button 1|2, then wait six seconds.
REMOTE ENTRY TRANSMITTER
Up to four hand held (key fob) transmitters can
control electronic door lock system.
To unlock the entry door:
• Press the UNLOCK button on the
transmitter. This will unlock the door and
disarm the anti-theft system.
To unlock all compartments:
• Press UNLOCK a second time within five
seconds of the first unlock. If more than five
seconds pass pressing UNLOCK will only
unlock the entry door.
To lock all doors and arm the anti-theft system:
• Press LOCK on the transmitter once.
To confirm that the door and compartments have
been locked and that the anti-theft system is
armed:
• Press LOCK again within five seconds of the
first lock. The horn will chirp once if the door
and compartments have locked. If the door
or one of the compartments are open, a door
ajar signal prevents arming of the system.
To set off the personal security alarm:
• Press the red PANIC button on any
transmitter. The horn will sound and the
headlamps will flash for a maximum of three
minutes.
To deactivate the personal security alarm:
• Press the red PANIC button again on any
transmitter or turn the ignition key ON.
Note: the remote entry features will not function
when the ignition is in the ON or ACC. position.
PROGRAMMING TRANSMITTERS
To program additional transmitters or replacing a
lost or broken transmitter, all transmitters for a
vehicle must be programmed at the same time.
The receiver assembly module erases all
previous transmitters from memory. When the
transmitters are programmed or reprogrammed,
the receiver assembly module can store up to
four transmitters in memory.
To program or reprogram transmitters into the
remote/keyless entry system, perform the
following steps:
1. Make sure that the anti-theft system is not
armed or triggered.
2. Turn the ignition key from OFF to ON five
times within ten seconds, ending in ON.
Refer to chapter 3, “Controls and
Instruments” for information on positions of
the ignition switch.
If the system has successfully entered program
mode, it will lock then unlock all doors.
3. Press any button on a transmitter. The
doors will lock and unlock to confirm that the
transmitter has been programmed. Repeat
for each other transmitter.
If the door locks do not respond for any
transmitter, wait a few seconds and press the
button again. If the doors still fail to respond,
call your service representative.
4-17
To Next Page
Loading...
Need help?
General
