EasyManuals Logo

PREVOST XL2 User Manual

PREVOST XL2
121 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
CONTROLS AND INSTRUMENTS
To confirm that the door and compartments have
been locked and that the anti-theft system is
armed:
Press LOCK again within five seconds of the
first lock. The horn will chirp once if the door
and compartments have locked. If the door or
one of the compartments are open, a door
ajar signal prevents arming of the system.
To set off the personal security alarm:
Press the red PANIC button on any
transmitter. The horn will sound and the
headlamps will flash for a maximum of three
minutes.
To deactivate the personal security alarm:
Press the red PANIC button again on any
transmitter or turn the ignition key ON.
Note: the remote entry features will not function
when the ignition is in the ON or ACC. position.
IGNITION SWITCH
06354
The ignition switch is located on the lower left side
of the dashboard. It has four positions:
Off
In the OFF position, ignition cannot take place.
The key can be removed in this position.
The electrical circuits are not activated when the
switch is in this position. Only the accessories
connected directly to the batteries can be
activated. These are: the coolant heater and
water pump, the keyless entry system and anti-
theft alarm, the central locking system, entry lights
electric horn and Message Center Display (MCD).
Maintain the switch in this position when parked
overnight or for an extended period.
Accessories
To operate the accessories only, turn the ignition
key counterclockwise. The key cannot be
removed in this position.
The battery electrical circuits are activated when
the switch is in this position or when the hazard
flashers are activated.
The features enabled when the key is in the ACC
position are all those linked directly to the battery
plus the exterior temperature display, the radio or
entertainment system, exterior and interior
lighting.
On
To place ignition switch to ON, turn the key
clockwise to the first position. The key cannot be
removed in this position.
The electrical circuits activated are the same than
when the switch is in the ACC position plus the
transmission, engine and accessories, ABS
system, wipers, level low system, dashboard
cluster gauges and buzzers, air horn and air dryer
heater are activated when the key is in this
position. Do not leave the key in this position
unless the engine is running.
Start
Turn the key clockwise to the second position and
release as soon as the engine starts. The key will
return to the ON position. If the engine did not
start, return the ignition key to the OFF position
before trying to restart the engine.
Caution: To avoid overheating the starter, do not
engage the starter for more than 15 seconds at a
time. Allow the starter to cool before trying to
restart the engine.
The features activated when the engine is running
are all those described above plus the HVAC
system and day time running lights. The optional
ether cold-start system is automatically
deactivated once the engine runs.
3-3

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the PREVOST XL2 and is the answer not in the manual?

PREVOST XL2 Specifications

General IconGeneral
BrandPREVOST
ModelXL2
CategoryMotorhomes
LanguageEnglish

Related product manuals