EasyManuals Logo

PREVOST XL2 User Manual

PREVOST XL2
121 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #76 background imageLoading...
Page #76 background image
CARE AND MAINTENANCE
ENGINE COMPARTMENT 14044
Check fluid level as follows:
1. Stop engine, open engine compartment and
place rear start switch to OFF position;
2. Unscrew and remove the dipstick located on
top of the fluid tank and wipe with a clean
rag;
3. Replace dipstick in tank, then remove to
check fluid level;
4. Add hydraulic fluid until it reaches the FULL
mark on the dipstick (use Dexron II, Dexron
IIE, Dexron III or Mercon fluid type);
5. Place engine rear start switch to NORMAL
position. Close engine compartment door;
6. Replace and tighten dipstick.
RADIATOR FAN GEARBOX OIL LEVEL
The radiator fan is belt-driven by the engine
crankshaft pulley through a gearbox and drive
shaft. A dipstick located on top of the gearbox is
used to check the radiator fan gearbox oil level.
ENGINE COMPARTMENT 05062
Check radiator fan gear box oil level as follows:
1. Stop engine, open engine compartment and
place rear start switch to the OFF position;
2. Open engine compartment door and place
engine starter switch to OFF position;
3. Remove the dipstick located on top of the
gearbox and wipe with a clean rag;
4. Insert dipstick in gearbox case, then remove
again to check mark;
5. Add, if necessary, MOBIL SHC 630 synthetic
lubricant (Prévost #180217) until it reaches
"FULL" mark;
Note: Mobil SHC 630 is a new lubricant and is
not compatible with SHC 634 lubricant that was
previously used.
6. Reinsert the dipstick;
7. Place engine rear start switch to NORMAL
position. Close engine compartment door;
8. Set battery master switch to ON position.
WHEEL BEARING OIL LEVEL
The oil level for the front and tag axle wheel
bearings must be maintained to the level marked
in the cap. A sight glass is provided for
convenient verification of oil level. Oil level
should be checked daily and must be maintained
between the ”ADD” and “FULL” level mark in the
sight glass.. Wait at least 15 minutes before
checking the oil level after the vehicle has been
driven to make sure the bearing oil has settled.
Differential oil is used to lubricate the drive axle
wheel bearings. Maintain the differential oil at the
7-5

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the PREVOST XL2 and is the answer not in the manual?

PREVOST XL2 Specifications

General IconGeneral
BrandPREVOST
ModelXL2
CategoryMotorhomes
LanguageEnglish

Related product manuals