VEHICLE INTERIOR
switch up to raise seat or push switch down to
lower seat.
SEAT CONTROLS 18040
Tilt (front) (3)
Pull switch up to raise front section of seat. Push
switch down to lower front section of seat.
SAFETY BELTS
The driver’s seat is equipped with a retractable
safety belt as required by State, Provincial and
Federal regulations. To fasten, pull seat belt out
of the retractor and insert the latch plate into the
buckle until it clicks. No special adjustment is
required since the reel device is self-adjusting. If
seat belt operation becomes defective, report to
Manufacturer's Service Center.
SEATBELT 18028
Note: The safety belt must be pulled out slowly
and continuously, otherwise it will lock the reel
before the latch plate reaches the buckle. If this
happens, allow the belt to retract completely and
repeat the procedure correctly.
Warning: A snug fit with the lap belt positioned
low on the hips is necessary to ensure motorist's
safety. The belt should not be worn twisted.
Avoid pinching belt and/or belt hardware in seat
mechanism. Do not wear belt over rigid or
breakable objects, such as eyeglasses, pens or
keys as these may cause injuries.
Caution: Never bleach or dry clean safety belt.
To unfasten belt, press the red button in center
of buckle and allow belt to retract. If the belt
does not fully retract, pull it out and check for
kinks or twists. Make sure that it remains
untwisted as it retracts.
Warning: Safety belts should always be worn
by motorists using seats supplied with belts
since this is required by most State and
Provincial laws.
SEATBELT 18029
STEERING WHEEL ADJUSTMENT
Push on the valve button with the left foot to
unlock the steering wheel for tilt and telescopic
adjustment.
Warning: Do not adjust the steering wheel
while the vehicle is moving. Loss of control
could result. Park the vehicle safely and apply
parking brakes before adjusting the steering
wheel.
2-2
To Next Page
Loading...
