CARE AND MAINTENANCE
Caution: Be sure not to reverse filter upon
installation.
DRIVER’S AREA FILTERS
The driver HVAC system's air filters are located
behind the R.H. console. To gain access to the
A/C filters, unscrew the grill located at the top
step of the entrance door steps. Remove the
filters for cleaning or replacement.
DRIVER'S AREA AIR FILTER REMOVAL 22172
CABIN SYSTEM AIR FILTER
The central HVAC system's air filters are located
in the evaporator compartment on L.H. side of
the vehicle. To gain access, open evaporator
compartment door. Remove filter panel by
unscrewing the six fixing screws. Slide out the
filter for cleaning.
Caution: Be sure not to install filter in inverted
position.
CABIN SYSTEM AIR FILTER REMOVAL 22178
HOSE INSPECTION
Inspect hoses regularly to ensure efficient,
economical and safe operation of the engine and
related equipment.
LUBRICATION
Grease all lubrication points during scheduled
maintenance. For heavy loads or extended use,
lubricate more often. Refer to the Maintenance
Manual, section 24 for information on lubrication.
PRE-STARTING INSPECTION
WITH ENGINE STOPPED:
Inspect hoses for leaks. Carefully inspect all
fittings, clamps and ties. To prevent chafing,
make sure hoses are not touching shafts,
couplings, heated surfaces, sharp edges or other
parts. Since hose clamps and ties can vibrate
loose or fail over time, inspect frequently and
tighten or replace as necessary.
Check for loose nuts and bolts. Visually inspect
safety of compartment door latches. Test
operation of all exterior lights.
7-9
To Next Page
Loading...
Need help?
General
