5–12 Replacement Procedures
Installation
1. Feed the intermediate cable assembly (10) through the card cage
opening and install tie wraps and cable restraints.
2. Connect connectors CO+ and CO– (8 and 9) and install the cover open
switch assembly (7). (See page 5–80.)
3. Connect connector PMD (5) to paper detector switch assembly
connector PMD(P) (6).
4. Connect connector P1(P) (3) to the platen interlock switch assembly (4).
5. Install the screws (1) securing the intermediate cable assembly
connector P1 (2) to the bottom of the card cage.
6. Insert the ground lug under the screw and tighten the screw.
7. Install the mechanism driver PCBA (page 5–48).
8. Install the common controller PCBA (page 5–46).
9. Install the paper guide assembly (page 5–42).
10. Return the printer to normal operation (page 5–86).
To Next Page
Loading...
