5–16 Replacement Procedures
Installation
1. Feed the multi I/O ribbon cable (9) from the lower cabinet up into the
opening at the right rear of the card cage. Route the ribbon cable against
the right rear wall of the cabinet.
2. Install four screws (7) securing the multi I/O cable assembly mounting
plate (8).
3. Latch the multi I/O ribbon cable into the cable restraints (3) located on
the upper rear and upper right cabinet walls.
4. Engage the multi I/O ribbon cable in the holders on the rear wall of the
card cage. Remove the common controller PCBA if necessary (page
5–46).
5. Connect the multi I/O ribbon cable connector (5) to connector J1 (6) on
the common controller PCBA and close the latches (4).
6. Move the service panel (2) into position and install the six screws (1).
7. Install the paper fence through the front door.
a. Tilt and install the paper fence in the top right hole in the service
panel.
b. Install the fence in the bottom center hole in the cabinet floor.
c. Set the top left side of the fence in the support bracket and tie
wrap it in place.
8. Close the cabinet doors.
9. Install the paper guide assembly (page 5–42).
10. Return the printer to normal operation (page 5–86).
To Next Page
Loading...
