Procon V3D - Introduction and Setup; Graphic Symbols and Important Information

H - I - J PROGRAMMER’S MANUAL V8.94.11-
- 5 -
Thank you for having decided in favour of PROCON Ltd’s frequency converter.
This Instruction Manual contains all information necessary for starting up, programming and operating the frequency
converter.
Instructing graphic symbols
Following graphic symbols will be used in this manual:
8
This symbol is used for those instructions whose negligence could cause personal injury, damage in the
equipment and property damage.
i
Important information
Important information
8
CAUTION
Prior to setting up, operating, maintaining or servicing the frequency converter please carefully read this
Programmer’s manual!
Please entirely comply with all safety measures, warnings and instructions described in the manual!
Absolutely follow the safety notes described in the manual!
The operating company is responsible for any personal injury and property damage caused by the negligence of the
warnings described in the manual.
Programming the frequency converters
The tools, which can be used for programming:
• Programming terminal
• Operating terminal
• Controlling terminal
• Computer
i
When connecting more than one tool, the programming can be made from any of them, and the process will
be shown on the other tools, too.
With remote control, when transmitting “Write” messages on the MOD bus (e.g. reference signal setting),
parameter setting with the terminal is not possible.
In this case, the parameters can be modified with remote control, or for the duration of the parameter setting
the “Write” messages on the bus have to be suspended.