Profitec DRIVE - Machine Installation; Electrical connection; Water supply connection

Translation of the original German user manual
38
ENGLISH
Voltages: EU: 230 V Frequency: EU: 50 Hz
UK: 230 V UK: 50 Hz
NZ: 230 V NZ: 50 Hz
AU: 230 V AU: 50 Hz
US: 115V US: 60 Hz
JP: 100 V JP: 50/60Hz
Power: 1.600 W
Water tank: ca. 2.8 l
Measurements: B x T x H / 340 mm x 485 mm x 420 mm
Measurements with portalter: B x T x H / 340 mm x 580 mm x 420 mm
Weight: 31 kg
4. MACHINE INSTALLATION
i
The installation must be carried out exclusively by a qualied specialist in compliance with
valid laws and according to the local regulations, technical requirements, and standards.
4.1 Preparation for installation
i
• Place the machine on an even and stable surface.
• Make sure that the machine is on a water-resistant surface in case of water spillage
or leakage.
• Never place the machine on hot surfaces.
4.2 Electrical connection
i
• Make sure that the local main voltage supply corresponds to the information given on
the type plate on the front panel of the espresso machine.
• Make sure that you use the correct power plug corresponding to your country.
• Plug the machine into a grounded socket only and do not leave it unattended.
• Do not roll or bend the power cord.
• Do not use an extension cord / do not use a multiple socket.
4.3 Water supply connection
i
Important
Ensure that the xed water connection of your machine is connected to a potable water
supply having an operating pressure at least 100 kPa (1 bar) and does not exceed 200 kPa.
We recommend using a pressure regulator and a shut-off valve in case the operating
pressure exceeds 200 kPa (2 bar) or frequently uctuates.
The shut-off valve should be easily accessible, so that the water ow may be stopped at
any time. Make sure that the shut-off valve is closed or turned off when the machine is
not in use to prevent any possible water leakage.
The machine is delivered in the water tank mode by default.
i