Profitec DRIVE - Machine in Operation with Water Tank

Translation of the original German user manual
40
ENGLISH
Figure 1 (Rear view) Figure 2
i
Important!
• If you haven‘t programmed automatic on/off times for your machine (see chapters
8.2 - 8.6), make sure to close the shut-off valve at the end of the machine‘s
operation, switch off the machine and unplug it after each use.
• If you are not going to use the machine for a long time, we recommend emptying
the machine. To do this, let the machine heat up, then switch it off and remove the
water via the brew group and the hot water wand. Make sure that the water supply is
disconnected.
To rell, follow the initial set up(see chapter 5).
The residual water is disposed off periodically by emptying out the water drip tray.
4.3.3 Machine in operation with water tank
The machine is delivered in the water tank mode by default.
When operating the machine with the water tank, turn the control valve in the direction of the water
connection nozzle (see gure 3). Additionally, in the menu, set the “Tank Mode” option to “ON“
(see gure 4).
Figure 3 (Rear view) Figure 3
i
Important!
• If you haven‘t programmed automatic on/off times for your machine (see chapters
8.2 - 8.6), make sure to close the shut-off valve at the end of the machine‘s
operation, switch off the machine and unplug it after each use.
• If you are not going to use the machine for a long time, we recommend emptying
the machine. To do this, let the machine heat up, then switch it off and remove the
water via the brew group and the hot water wand. Make sure that the water supply is
disconnected.
To rell, follow the initial set up(see chapter 5).
The residual water is disposed off periodically by emptying out the water drip tray.
Water connection nozzle
Rotary valve in
xed water position
(facing to the outside of
the machine)
Tank mode option “OFF“
i
Tank mode option “OFF“
Water connection nozzle
Rotary valve in
xed water position
(facing to the inside of
the machine)