Profitec DRIVE - Machine in use with direct water connection

Translation of the original German user manual
42
ENGLISH
i
The Drive has safety feature that prevents the boiler from overlling. It may happen that
the machine does not heat up during initial set-up or when a large amount of water is
dispensed through the hot water valve. In this case, please switch the machine off briey
and then on again.
Please note that the portalter, drip tray, cup tray and water tank are not suitable for the
dishwasher.
5.2 Machine in use with direct water connection
1. Connect the metal hose.
2. Set the water connection to operate witha xed water connection (see chapter 4.3.1 and 4.3.2).
3. Plug the machine into the power outlet and press the power switch (LED ring lights up). The machine
is now turned on. The display shows "Fill."
4. Ensure that the ”Flow Control“ is opened with at least one turn. For more information, see
chapter 7.2.
Fill mode “Fill“
Place a small container (e.g. a milk jug) under the brew group. Move the brew lever up and the pump
will start to ll the brew boiler. Rinse the machine for at least 30 seconds until water comes out of
the brew group. When you move the the brew lever down „Fill“ should have disappeared from the
display.
5. After the brew boiler has been lled, the steam boiler is automatically lled with fresh water.
6. As soon as the lling of the steam boiler is nished, you no longer hear any pump noise.
7. The machine starts heating up the boiler. The PID display shows ”Heating Up“. You can nd out more
about this in chapter 8.7.
8. As soon as the boiler temperature is shown on the display, the machine is ready for use. Place the
cups on the cup tray so that they are always preheated.
i
Ensure that the machine is placed on a level stable, and water resistance surface.
Rinse the machine with 2 - 3 water tank llings before making the rst coffee. To do
this, allow water to run from the brew group and the hot water pipe. More hot water can
be drawn with the machine turned off (see 9.4).
The DRIVE has a safety feature that prevents overlling of the boiler. It may occur that the
machine does not heat up during the initial setup or when a large amount of water has
been dispensed through the hot water valve. In this case, please briey turn the machine
off and then on again.
Always ensure that when the machine is not in use, the brew lever is turned down and
there is a shut-off valve to be able to cut off the water supply at any time.
Please note that the portalter, drip tray, cup tray and water tank are not suitable for the
dishwasher.