Profitec DRIVE - Page 59

Translation of the original German user manual
59
ENGLISH
Follow the steps as indicated below:
1.
Brew group in the beginning
2.
Use a at screwdriver to pry out
the shower screen and the
group gasket
3.
The shower screen and the
gasket are now nearly removed
4.
Remove the shower screen and
the gasket completely
5.
Keep the new spare parts ready
at hand (the rounded side of the
group gasket faced upwards to
the brewing group)
6.
Clean the group with a brush.
Lock the shower screen rmly
into the gasket
7.
Insert the shower screen into
the brew group
8.
Take the portalter without lter
9.
Clamp the portalter into the
brew group
10.
Then, move the portater until
the shower screen is locked
rmly into the gasket
11.
Now you can easily lock the
portalter into place
12.
The group is ready for use
The machine can be used again, as described in chapter 9.1 of the instruction manual.
The steam nozzle is blocked.
Clean the holes of the steam nozzle carefully with a thin piece of metal such as a needle or a paper clip.
For this purpose, the steam nozzle may be unscrewed as well.