Profitec DRIVE - Page 62

Translation of the original German user manual
62
ENGLISH
Problem Possible Cause Troubleshooting
Little or no crema on the top of
the coffee
The grind is not ne enough
Use a ner grind. Tamp the
ground coffee more rmly.
Reduce the brewing pressure.
The coffee is too old Use fresh coffee.
There is too much chlorine in
the water
Use a chlorine lter.
The amount of ground coffee is
not enough
Use the right coffee amount
(The marking inside the lter
basket can help you nd the
right amount of coffee).
Shower screen is dirty Clean the brew group.
Weak “body”
The grind is not ne enough Use a ner grind.
The coffee is old Use fresh coffee.
The amount of ground coffee is
not enough
Use the right coffee amount
(The marking inside the lter
basket can help you nd the
right amount of coffee).
Shower screen is dirty Clean the brew group.
The machine is switched on,
but the machine does not work.
Display: Fill the water tank
Water tank not correctly
inserted
Switch on/off the machine.
Make sure that the oater in
the water tank is in the correct
position. (The side of the oater
with the magnet point must face
towards the inside of the
machine. The oater itself must
be inserted with the magnet
point on the upper part of the
oater).
Fixed water mode, but menu
setting “Tank Mode“ = ON
(=water tank setting).
Machine does not draw water
from the pipe.
Set the „Tank Mode“ in the menu
to “OFF“ (= xed water setting).