PROLiNK® PRC3801 Wireless AC1200 MU-MIMO Dual-Band Gigabit Router
• Aggregation: To enable frame aggregation which increase throughput by sending two or more
data frame in single transmission. By default this feature is enable.
• Short GI: This function is recommended for it will increase the data capacity by reducing the
guard interval time.
• AP Isolation: This function can isolate wireless stations on your network from each other.
Wireless devices will be able to communicate with the router but not with each other. To use
this function, check this box. AP Isolation is disabled by default.
• TX Beamforming: This function help to improve range and data rate for connected client or
device. By default this feature is Enable. To disable, check the Disable box.
• MU-MIMO: Enable this function will help PRC3801 to transmit data for multiple user
simultaneously and at same time improve the wireless performance for 5GHz. By default this
feature is Disable. To enable, check the Enable box.
• RF Output power: To control the RF power of wireless signal. By default it will be set to
maximum 100%. You are allow to reduce the RF power to accommodate your wireless
environment.
• Enable Band Steering: This will allow client to be steering automatically to correct frequency
band that support by the device to experience best performance of wireless signal. By default
this setting will be disable. To enable the device, check Enable box and select which prefer band
either 2.4GHz or 5GHz. Recommended to use 5GHz as it will steer 5GHz supported device to
5GHz band which is less congested band.
Access Control
Access Control (5GHz) will restricted and allow listed client by MAC address to connected with MAC
5GHz frequency band. “Allow Listed MAC Addresses” will enable client to connect with 5GHz
wireless signal. “Deny Listed MAC Address” will denied the listed MAC Address from connected with
5GHz wireless signal.
18
To Next Page
Loading...
