PROLiNK® PRC3801 Wireless AC1200 MU-MIMO Dual-Band Gigabit Router
Short for a busy wireless network with high network traffic. Select Long if your wireless
network is composed of older or legacy wireless devices.
• BG Protection: To ensure device with B and G are able to co-exist on the same network. By
default it is disable, to enable it check on the Enable box.
• Aggregation: To enable frame aggregation which increase throughput by sending two or more
data frame in single transmission. By default this feature is enable.
• Short GI: This function is recommended for it will increase the data capacity by reducing the
guard interval time.
• AP Isolation: This function can isolate wireless stations on your network from each other.
Wireless devices will be able to communicate with the router but not with each other. To use
this function, check this box. AP Isolation is disabled by default.
• 20/40MHz Coexist: Disabling this option allows your 2.4GHz wireless to stay in supporting the
max speed. Enabling this option may reduce the max speed of your 2.4GHz wireless to the half
when there is another wireless network detected in your environment; this is to avoid
inteference between wireless networks and to get along with other wireless networks in the
environment.
• TX Beamforming: This function help to improve range and data rate for connected client or
device. By default this feature is Enable. To disable, check the Disable box.
• RF Output power: To control the RF power of wireless signal. By default it will be set to
maximum 100%. You are allow to reduce the RF power to accommodate your wireless
environment.
28
To Next Page
Loading...
