PROLiNK PRC3801 - Port Forwarding

PROLiNK® PRC3801 Wireless AC1200 MU-MIMO Dual-Band Gigabit Router
• Name: Enter client or device name
• QoS Type: Choose type of QoS either by IPv4, MAC Address, IPv6, PHYPORT or DSCP.
• Protocol: Select type of protocol to use for QoS. It can be either TCP, UDP or both.
• Select IP: Select connected client IP Address.
• Local IP Address: Enter local IP Address range of client or device (if QoS type is IPv4).
• Local Port: Enter local port range of client or device (if QoS type is IPv4).
• Remote IP Address: Enter remote IP Address range of client or device (if QoS type is IPv4).
• Remote Port: Enter remote port range of client or device (if QoS type is IPv4).
• IPv6 Address: Enter IPv6 Address of client or device (if QoS type is IPv6).
• MAC Address: Enter MAC Address of client or device (if QoS type is MAC).
• PHYPORT: Enter Physical Ethernet port of connected client or device (if QoS type is
PHYPORT).
• DSCP: Enter DSCP number of client or device (if QoS type is DSCP).
• Mode: Select QoS mode for “Guaranteed minimum bandwidth” or “Restricted maximum
bandwidth”.
• Uplink Bandwidth (Kbps): Enter value of upload limitation value according to the QoS mode.
• Downlink Bandwidth (Kbps): Enter value of download limitation value according to the QoS
mode.
• remark dscp: Insert a remark on DSCP configuration.
• Comment: Insert comment of the DSCP configuration as references.
53