ProMinent S1Cb User Manual

8.7.2 Adjusting the Display (DISPLAY menu)
Display
Contrast
End
Main menu
Mode
Settings
Service
Information
Language
Service
Clear counters
Display
HMI logout
Security
End
Contrast
0 4 0 %
Continuous
display
In the
‘DISPLAY’ sub-menu the LCD screen contrast can be changed
using the
[Arrow keys] .
8.7.3 HMI logout
HMI logout
Logout with OK
Back with ESC
Main menu
Mode
Settings
Service
Information
Language
Service
Clear counters
Display
HMI logout
Security
End
Service
HMI login
End
HMI logout
HMI successfully
logged out!
Continuous
display
In this menu you can log into and out of the pump HMI:
To logout run through the menu above. Thereafter the HMI can be
removed from the pump.
Logging on takes place automatically whenever the HMI cable is con‐
nected to the CAN port.
If the HMI must be formally logged into: Logging on via the menu occurs in
exactly the same way as logging off.
If the HMI is disconnected from the CAN bus, without first logging it off, the
pump remains stationary.
WARNING!
An on/off switch may not be fitted on the pump, dependent
on the identity code and installation.
To be able to switch off the pump (to a zero-volts state) inde‐
pendently from the entire installation (e.g. for repair), use an
electrical isolating device in the mains supply cable, e.g. a
mains switch or a plug / socket combination. Clearly identify
this isolating device as such.
Set-up
61

ProMinent S1Cb Specifications

General

Brand	ProMinent
Model	S1Cb
Category	Water Pump
Language	English