250
Promise Technology
Pegasus32 Series
Format drives for Mac JHFS+ with Mac Disk Utility
Follow these instructions to change the le system to JHFS+ using Mac Disk Utility.
1. If the Mac Driver of Pegasus32 has been installed and loaded successfully, you will see
the NTFS volume on your Desktop. Note that the Volume is read-only until you change
to JHFS+ le system.
• If Pegasus32 is connected to a Thunderbolt port on your Mac, the volume icon looks like this:
• If Pegasus32 is connected to a USB port on your Mac, the volume icon looks like this:
WARNING
Converting the le system will erase the entire contents of the drives on
Pegasus32. All data currently on the hard drives will be lost.
Make sure you back up all data to another system before proceeding.
To Next Page
Loading...
Need help?
General
