Promise Technology Pegasus32 R6 - Page 55

39
Installation and Setup for Windows UsersPegasus32 Product Manual
Step 3: Power On Pegasus32
Follow these steps to connect the power cord and power on the Pegasus32.
1. AttachthepowercordonthebackofthePegasus32unit.
(Seepage 38toseeanillustrationofthebackofdevice)
2. Plug the other end into a power source.
3. PressthePowerButton.(Seeillustrationoffrontofdevicebelow).
YouwillobservethatthePower Button LED turns orange.
Ittakesabout30secondstobootthePegasus32unit.Whenfullybooted:
• ThePowerButtonLEDturnsblue.
• ThedrivecarrierPower/StatusLEDsturnblue.
Pegasus32 boot up LED behavior
Link LED
Powerbutton/
Status LED
DrivePower/
Status LED
Drive Carrier
Drive Activity LED