SECTION 7—SEAT
Part No. 1125085 47 Pronto
®
M50
™
, M51
™
and M61
™
with SureStep
™
Adjusting Seat Position on Seat Base
WARNING
Refer to the table in FIGURE 7.7 for proper seat post mounting positions. For users
over 220 lbs - seat MUST be in the 1-inch back position (FIGURE 7.7) when using
seat post mounting holes 3, 4 and 5 (FIGURE 7.6). Refer to Adjusting the Seat
Height on page 46.
NOTE: For this procedure, refer to FIGURE 7.7.
1. Remove the seat. Refer to Removing/Installing the Seat Assembly on page 44.
2. Remove the four (4) mounting screws and washers securing the seat adapter plate to
the seat base (FIGURE 7.7).
3. Separate the seat adapter plate from the seat base.
4. Refer to FIGURE 7.7 to determine the correct mounting holes to achieve the desired
seat position.
5. Align the mounting holes on the seat adapter plate (determined in STEP 4) with the
mounting holes on the seat base.
6. Using the four (4) mounting screws and washers, secure the seat base to the seat
assembly. Securely tighten.
7. Reinstall the seat. Refer to Removing/Installing the Seat Assembly on page 44.
To Next Page
Loading...
