RDM0001/3_2 Page 46 of 70 © 2015 - 2017 Protec Fire Detection plc
13.15 Disable all fire Links
The fire link is the output used to signal a fire event to a remote monitoring centre.
13.16 Disable all fault Links
The fault link is the output used to signal a fault event to a remote monitoring centre.
13.17 Disable all fire protection outputs
The fire protection output is the output used to trigger another panel controlling fire
protection equipment.
13.18 Disable all alarm outputs
‘Alarm’ outputs are sounder devices that turn on when there is a fire event and turn off when
the system is silenced.
13.19 Disable all control outputs
‘Control’ outputs are typically interface devices that shutdown plant equipment when there is
a fire event. These shutdowns remain in place when the system is silenced and only cancelled
when the system is reset.
13.20 Disable all non-fire outputs
‘Non-fire’ outputs are typically interface devices that do not control equipment when there is
a fire event. These outputs are not affected when the system is silenced or reset.
To Next Page
Loading...
