RDM0001/3_2 Page 52 of 70 © 2015 - 2017 Protec Fire Detection plc
13.28 Zone Test
Activations from a zone programmed into test mode will not activate the Fire Link
output. Remember to take the zone out of test mode when testing has been completed.
Touch Zone Test to select a zone for testing.
Note: - It is possible to select and test a Zone that is not used.
If a device is activated in a zone under test then only the alarm outputs, including talking sounders,
on that panel will be activated (assuming the alarm outputs have been enabled during test – see
section 13.29).
To Next Page
Loading...
