This equipment has been manufactured in conformance with the
requirements of all applicable EU council directives and regulations.
BS EN 54-2:1997 + A1:2006
BS EN 54-4:1997 + A1:2002 + A2:2006
Control / Indicating and Power Supply equipment for fire detection
and fire alarm systems for buildings
6500/6600 Fire Alarm Control Panel
Options Provided
7.8 Output to fire alarm devices
7.9.1 Output to fire alarm routing equipment
7.9.2 Alarm confirmation input from fire alarm routing equipment
7.10.1 Output to automatic fire protection equipment (type A)
7.10.2 Output to automatic fire protection equipment (type B)
7.10.3 Output to automatic fire protection equipment (type C)
7.10.4 Fault monitoring of fire protection equipment (type B)
7.11 Delays to outputs
7.12.1 Dependencies on more than one alarm signal(Type A)
7.12.2 Dependencies on more than one alarm signal(Type B)
7.12.3 Dependencies on more than one alarm signal(Type C)
7.13 Alarm counter
8.3 Fault signals from points
8.9 Output to fault routing equipment
9.5 Disablement of each point
10 Test condition
Supports more than 512 fire detectors and/or manual call points
(clause 13.7b)
Control & Indicating:
Performance under fire conditions: Pass
Response delay (response time to fire): Pass
Operational reliability: Pass
Durability of operational reliability, Temperature resistance: Pass
Durability of operational reliability, Vibration resistance: Pass
Durability of operational reliability, Electrical stability: Pass
Durability of operational reliability, Humidity resistance: Pass
Power supply:
Performance of power supply: Pass
Durability of operational reliability, Temperature resistance: Pass
Durability of operational reliability, Vibration resistance: Pass
Durability of operational reliability, Electrical stability: Pass
Durability of operational reliability, Humidity resistance: Pass
To Next Page
Loading...
