RDM0001/3_2 Page 54 of 70 © 2015 - 2017 Protec Fire Detection plc
13.30 Complete System Test
Complete System test will put the entire fire system into test mode. During
complete system test, the fire link output will not transmit the fire signal to a
remote monitoring centre. Remember to take the system out of complete system
test mode when testing has been completed.
Touch Complete System Test to put the entire fire system into test mode.
Touch to cancel the Complete System Test.
Note: - When a device is activated in complete test mode, the alarm outputs, including talking sounders, will
be activated on all panels (assuming the alarm outputs have been enabled during test – see section 13.29).
To Next Page
Loading...
