Tsunami QB-8100 Series (100 Mbps/5 Mbps Models) Installation and Management Guide 52
Figure 4-7 Wireless interface properties
2. Enter the appropriate parameters. See the following table that lists the parameters and their descriptions.
3. Click OK.
NOTES:
• If World/Russia frequency domain is selected, establishing WORP link might take longer time because the End Point
B has to scan relatively more number of channels.
• When you modify wireless parameters and click COMMIT, it may result in brief interruption of service.
Parameter Descriptions
Channel Bandwidth This parameter specifies the channel bandwidth. By default, it is
set to 20 MHz. 40 MHz can be selected for higher throughputs
depending on the distance and signal quality. 5 and 10 MHz can
be selected for greater flexibility in spectrum selection.
To Next Page
Loading...
Need help?
General
