QNAP QMiroPlus-201W User Manual

1. Open QuRouter.
2. Go to QVPN > QVPN Settings .
3.
Click .
4.
Click .
5. Configure the QBelt server settings.
Setting Description
Client IP pool Specify a range of IP addresses available to connected VPN clients.
Important
By default, this server reserves the use of IP
addresses from 10.6.0.0/24. If another connection is
configured to use this range, an IP conflict error will
occur. Before adding this server, ensure a VPN client
isn't configured to use this range as well.
Service Port (UDP) Select the port used to access the server.
Tip
Default port: 443
Pre-shared key Specify a key (password) to verify connecting VPN clients.
DNS Specify a DNS server for the QBelt server.
Note
The DNS server limitation is 1 by default.
6. Click Apply.
QuRouter saves the QBelt server settings.
Enabling L2TP VPN Server
1. Open QuRouter.
2. Go to QVPN > QVPN Settings .
3.
Click .
Important
You cannot enable the L2TP server if the router is using the QuWAN service.
To enable the L2TP server, you must first leave the organization and QuWAN service by
clicking Leave the organization and QuWAN in QuWAN.
4.
Click
.
5. Configure the L2TP server settings.
QMiroPlus-201W User Guide
Network Settings 48

QNAP QMiroPlus-201W Specifications

General

Brand	QNAP
Model	QMiroPlus-201W
Category	Network Router
Language	English