QuadTech 1730T - Operation; Alarm Mode, Handler Mode, and GPIB EOS Code

Operation 150821/A4 Page 33 of 110
2.3.10 ALARM Mode
The type of audible alarm can be set to PULSE or CONTINUOUS during judgment in the
measure display. The instrument default setting is PULSE. To change the alarm mode press
[SYSTEM SETUP], [SYSTEM CONFIG] and the down arrow [⇓] until the box next to ALARM
MODE is highlighted, then press [F1] = PULSE for the alarm to sound in a pulse tone or [F2] =
CONTINUOUS for the alarm to sound continuously.
<SYSTEM CONFIG>
PULSE
CONTINUOUS
CLEAR
PULSE
FAIL
07
04INTEG. CYCLE:
HANDLER MODE:
ALARM MODE:
SOUND MODE:
CONTRAST:
Select alarm to sound CONTINUOUSLY
Select alarm to sound as a PULSE
F2
F1
Go to HANDLER Mode
Go to SOUND Mode
Default: PULSE
2.3.11 HANDLER Mode
The handler interface mode can be set to CLEAR or HOLD. The instrument default setting is
CLEAR. When set to CLEAR, the handler interface will clear the last test result prior to each
subsequent measurement. When set to HOLD, the handler interface will hold the last test result
until the next measurement is made and displayed. To change the handler mode press
[SYSTEM SETUP], [SYSTEM CONFIG] and the down arrow [⇓] until the box next to
HANDLER MODE is highlighted, then press [F1] = CLEAR or [F2] = HOLD.
<SYSTEM CONFIG>
CLEAR
HOLD
04INTEG. CYCLE:
HANDLER MODE:
ALARM MODE:
SOUND MODE:
CONTRAST:
CLEAR
PULSE
FAIL
07
F2
Select handler to HOLD result
Default: CLEAR
Select handler to CLEAR result
F1
Go to GPIB EOS Code
Go to ALARM Mode
2.3.12 GPIB EOS Code
The End of String code for the IEEE-488 interface is set as “0Dh”, “0Ah” or “0Dh, 0Ah”. The
instrument default setting is “0Dh”. To change the GPIB EOS code press [SYSTEM SETUP],
[SYSTEM CONFIG] and the down arrow [⇓] until the box next to GPIB EOS code is
highlighted, then press [F1] = 0Dh, [F2] = 0Ah or [F3] = 0Dh, 0Ah.
0Dh, 0Ah
GPIB EOS CODE:
GPIB ADDRESS:
<SYSTEM CONFIG>
0Ah
F1
0Dh
Go to HANDLER Mode
Go to GPIB ADDRESS
Select end of string code = 0Dh
TRIGGER DELAY:
TRIGGER EDGE:
LINK 1320:
0Ah
OFF
FALLING
0000mS
17
F2
F3
Select end of string code = 0Ah
Select end of string code = 0Dh, 0Ah
Default: 0Dh