QuadTech 1730T - Operation; Storing Test Setups (STORE)

Operation 150821/A4 Page 53 of 110
2.5.2 STORE
The 1730T instrument’s STORE and RECALL functions are within the MAIN INDEX menu.
Press [MAIN INDEX], press [F1] = BINNING (or [F2] = COMPARE) then press [F2] = STORE
to access the store function.
When performing the STORE and RECALL functions, the 1730T instrument stores the
following information:
• Frequency
• Speed
• Level
• Parameter
• Range
• All Bin setting values (excluding the Bin Counter)
• All Compare setting values (excluding the Compare Counter)
There are 50 storage locations (00 – 49) in the 1730T instrument memory.
CORRECTION
< MAIN INDEX >
COMPARE
BINNING
Enter Compare function
Enter Binning function
Enter Correction function
F2
F3
F1
BIN COUNT
< MAIN INDEX BINNING >
BIN SET
STORE
RECALL
Set Bin Nominal, High & Low Values
Recall Results from Memory Location 00 -49
Store Results to Memory Location 00-49
PARAMETER:
AUX_HI:
NOMINAL:
AUX_LO:
+99999.9999 -
00000.0000 pF
Cs - D
+00000.0000 -
F3
F1
F2
F4
View Results by Bin # and Count
(Left & Right arrows also move cursor to next digit)
< MAIN INDEX BINNING >
DIGIT UP
DIGIT DOWN
DIGIT
Increase value of underscored digit
Move underscore cursor to next digit
Decrease value of underscored digit
PARAMETER:
AUX_HI:
NOMINAL:
AUX_LO:
+99999.9999 -
00000.0000 pF
Cs - D
+00000.0000 -
F3
F1
F2
F4
Go UP in
memory location
Go DOWN in
memory location
< MAIN INDEX BINNING >
DIGIT UP
DIGIT DOWN
DIGIT
Increase value of underscored digit
Move underscore cursor to next digit
Decrease value of underscored digit
ENTER STORE NUMBER:
THIS NIUMBER HAS DATA
02
F3
F1
F2
F4
Table: Bin 1-8 High and Low Values
TRIGGER
ENTER STORE NUMBER: 00
Press TRIGGER to store setup
If there is already data stored in the location chosen, this message will be displayed:
PRESS TRIGGER TO RECOVER!
PRESS OTHER KEY TO ESCAPE