QuadTech 1730T User Manual

Operation 150821/A4 Page 55 of 110
2.5.4 COMPARE
To set up a comparison test, use the COMPARE function. To access the COMPARE function,
press [MAIN INDEX] then press [F2] = COMPARE. Press [F1] = SETTING to set the primary
nominal high and low judgment values. Press [F2] = STORE to store the current COMPARE
setup or press [F3] = RECALL to recall a stored COMPARE setup. Press [F4] = COUNT to
view the COMPARE results and counts.
Notes on Compare Settings:
Setting COMPARE = ON-VAL will display the primary and secondary readings in addition to a
GO (PASS). A LO reading is lower than the set nominal value and a HI reading is higher than
the set nominal value.
Setting COMPARE = ON-Δ will display the difference between the measured value and the set
nominal value. A GO, LO, or HI judgment is also displayed.
Setting COMPARE = ON-Δ% will display the percent difference between the measured value
and the set nominal value. A GO, LO, or HI judgment is also displayed.
CORRECTION
< MAIN INDEX >
COMPARE
BINNING
Enter Compare function
Enter Binning function
Enter Correction function
F2
F3
F1
< MAIN INDEX COMPARE >
STORE
RECALL
Set Primary and Secondary Nominal, High
and Low Values
Store Compare settings
F3
F1
F2
F4
F4
< COMPARE SET >
DIGIT UP
DIGIT DOWN
MODE:
Increase underscored digit
Select Absolute or Percent (%) Value
Decrease underscored digit
F3
F1
F2
F4
< COMPARE COUNT >
SPEED:
TRIG.:
RESET
F3
F1
F2
F4
PRIMARY COUNT
GO:
LO:
198
TOTAL:
MAIN
INDEX
= COUNT to view the COMPARE results and counts
When finished SETTING Comparison values
COUNT
SETTING
Parameter: Cs - D
PRI_NOMINAL
PRI_LO_NOMINAL
PRI_HI_NOMINAL
+00000.0000pF
Recall Compare settings
View Compare results & counts
DIGIT
ABS
PARAMETER: Cs - D
PRI_NOMINAL:
SEC_NOMINAL:
SEC_HI_NOMINAL:
PRI_LO_NOMINAL:
PRI_HI_NOMINAL:
SEC_LO_NOMINAL:
+00000.0000pF
+00000.0000
+00999.9000pF
- 00999.9000pF
+00999.9000
- 00999.9000
Move underscored digit left on a single line
(Left and right arrows also move underscored digit)
Move backlit
box: UP
Move backlit
box: DOWN
- 00999.9000pF
+00999.9000pF
RANGE:
F
MAN
AUTO
Select measurement speed = Fast,
Medium or Slow
Select trigger = MAN, INT or EXT
Select measurement range = Auto or Hold
Clear COMPARE count
SECOND
HI:
0
0
COUNT
198
0
0
GO:
HI:
LO:
198

QuadTech 1730T Specifications

General

Brand	QuadTech
Model	1730T
Category	Measuring Instruments
Language	English