QuadTech 1855 - Table of Contents

Page 3 of 76
Contents
Warranty ....................................................................................................................5
Specifications ....................................................................................................................7
Accessories ....................................................................................................................11
Safety Precautions...............................................................................................................13
Condensed Operating Instructions....................................................................................15
Introduction - Section 1
1.1 Unpacking and Inspection........................................................................................ 19
1.2 Product Overview .................................................................................................... 19
1.3 Controls and Indicators............................................................................................ 20
1.3.1 Front Panel Controls and Indicators .......................................................... 20
1.3.2 Rear Panel Controls and Connectors ......................................................... 21
1.4 Installation .............................................................................................................. 22
1.4.1 Dimensions ................................................................................................. 22
1.4.2 Instrument Positioning................................................................................ 22
1.4.3 Power Requirements ................................................................................... 22
1.4.4 Safety Inspection......................................................................................... 23
Operation - Section 2
2.1 Terms and Conventions ........................................................................................... 25
2.2 Start-Up.................................................................................................................... 27
2.3 SYSTEM SETUP ................................................................................................... 27
2.3.1 Calibration ................................................................................................. 27
2.3.2 Memory Manage ........................................................................................ 27
2.3.3 System Configuration ................................................................................ 28
2.3.3.1 Test Parameter ........................................................................... 29
2.3.3.2 Beeper ........................................................................................ 29
2.3.3.3 Sound Mode ............................................................................... 29
2.3.3.4 Alarm Mode ............................................................................... 30
2.3.3.5 Trig Delay .................................................................................. 30
2.3.3.6 Trig Edge ................................................................................... 30
2.3.3.7 Handler Mode ............................................................................ 31
2.3.3.8 Contrast ...................................................................................... 31
2.3.3.9 GPIB Address ............................................................................ 31
2.3.3.10 RS232 Baud Rate ...................................................................... 32
2.3.3.11 Key Lock ................................................................................... 32
2.3.3.12 Line Frequency .......................................................................... 33
2.3.3.13 Charge Time .............................................................................. 33
2.3.3.14 Range Dwell .............................................................................. 33
2.3.3.15 Average ...................................................................................... 34
2.3.3.16 EXT Vm Display ....................................................................... 34