Page 52 of 76 Interface
Refer to paragraph 2.3.3.10. Setting the Baud Rate is done in the SYSTEM CONFIGURATION
function under SYSTEM SETUP settings:
• From the MEAS DISPLAY, press [SYSTEM SETUP]
• Press [F3] = SYSTEM CONFIG.
• Press [⇓] = until the box next to BAUD RATE is highlighted.
• Press [F1] = INCREASE or [F2] = DECREASE to select baud rate.
• Press [F4] to EXIT
3.1.3 RS232 Commands
The command set for the RS232 interface is the same as the IEEE-488 interface command set
listed in paragraphs 3.2.3 through 3.2.5 of this instruction manual.
NOTE
CR + LF is the necessary end code for the RS232 commands.
To Next Page
Loading...
