RadioLink AT10 User Manual

84
GOAL of EXAMPLE: STEPS: INPUTS:
Fine-tune hovering with the hovering
adjustments. Remember these affect
only the hovering (normal) condition.
Adjust throttle and collective pitch
curves until model hovers nicely. In
ÀLJKWDGMXVWFROOHFWLYHSLWFKDQGWKURWWOH
curves near hover point independently
with
HOV-THR
and
HOV-PIT
knobs.
6WRUHQHZVHWWLQJVDIWHUÀLJKW
Open the
HOV-THR
function.
for 1 second.
(If
BASIC
, again.)
C
to
HOV-THR
.
Optional: change which knob adjust
seach hovering curve.
NULL
locks in
curve in last stored position.
C
to
VR
.
to desired knob and direction.
Store the current dial settings prior to
selecting another model.
C
to
RATE
.
for one second to store.
or VR(C) to center.
Close.
Open the
HOV-PIT
function.
C
to
HOV-PIT
.
Store the current dial settings prior to
selecting another model.
C
to
RATE
.
for one second to store.
or VR(A) to center.
Close.
Where next?
THR-HOLD
: see p. 79.
Setting up the Idle-Ups: Throttle and Collective pitch Curves and Revo. Mixing
(
TH-CURVE, PIT-CURVE, REVO. MIX
) for idle-ups: see p. 80.
D/R
,
EXP
: see p. 30.
HIGH/LOW PITCH (
HI/LO-PIT
):
7KLVIXQFWLRQPD\EHXVHGWRDGMXVWWKHFXUYHVKLJKDQGORZVLGHLQGLYLGXDOO\IRUHDFKÀLJKWFRQGLWLRQQRUPDOLGOHXS
idle-up 2, idle-up 3, throttle hold).
Adjustability:
<RX PD\ GH¿QH KLJK DQGORZ VLGHUDWH WULP NQREV WKH KLJK VLGH SLWFK WULP
FRQWUROLVGH¿QHGDVWKHULJKWVLGHOHYHUDWLQLWLDOVHWWLQJ
• The conditions are activated in the
CONDITION SELECT
function (p.81).
• Both adjustments may be set to
MANUAL
, temporarily turning off the knob.
• Adjustments may be memorized and then return the knobs to center point to
use that amount of adjustment. Allows easy use of the trimming knobs for
multiple models.

RadioLink AT10 Specifications

General

Channels	10
Frequency	2.4GHz
Output Signal	PPM
Control Distance	1.5km
Compatibility	Compatible with most multi-rotor, airplane, helicopter and car models