SFC6400A/SFC1450A Synthesized Frequency Upconverter Table of Contents
TM106 – Rev. 1.1 xi
Appendix A – Remote ASCII
A.0 Control Commands ________________________________________________ A-1
A.1 Remote Help Menu (All)_____________________________________________ A-2
A.2 Status Command (All) ______________________________________________ A-5
A.3 Data (All) ________________________________________________________ A-8
A.4 Show Received Signal Strength Command (Upconverter Only)(S, P1:1, P1:8) A-10
A.5 Show Priority Command (B1: 8) _____________________________________ A-10
A.6 Set Current Channel Frequency Command (S, P1:1, P1:8)________________ A-11
A.7 Set Current Channel Gain Command (S, P1:1, P1:8) ____________________ A-12
A.8 Set Channel Command (S, P1:1, P1:8) _______________________________ A-12
A.9 Set Priority (B1: 8) ________________________________________________ A-13
A.10 Store Current Channel Settings (S, P1: 1, P1: 8) _______________________ A-15
A.11 RF On/Off Command (Upconverter Only) (All)_________________________ A-15
A.12 Change Input Attenuation Command (Upconverter Only)(S, P1: 1, P1: 8)____ A-15
A.13 Clear Faults Command (All) _______________________________________ A-17
A.14 Auto Mode Command (P1: 1, B1: 1, B1: 8)____________________________ A-17
A.15 Manual Mode Command (P1: 1, B1: 1) _______________________________ A-17
A.16 Manual Backup Command (B1: 8) __________________________________ A-18
A.17 Set Stored Gain For a Specified Channel (S, P1: 1, P1: 8)________________ A-18
A.18 Set Stored Frequency For a Specified Channel (S, P1: 1, P1: 8)___________ A-18
A.19 Erase (All) _____________________________________________________ A-18
A.20 Restart (All) ____________________________________________________ A-19
A.21 Learn (B1: 1, B1: 8) ______________________________________________ A-19
A.30 Read DAC Value by Index (All) _____________________________________ A-21
A.31 Write DAC Value by Index (All) _____________________________________ A-21
A.32 Get Gain Offset (Upconverter Only) _________________________________ A-22
A.33 Set Gain Offset (Upconverter Only)__________________________________ A-22
A.34 Dump Channel Table (All) _________________________________________ A-22
A.35 Dump Calibration Table Set (All) ____________________________________ A-23
A.36 Get Current DAC Value (All) _______________________________________ A-23
A.37 Get DAC Value for Frequency and Gain (All)___________________________ A-23
A.37 Error Messages _________________________________________________ A-24
To Next Page
Loading...