Table of Contents SFC6400A/SFC1450A Synthesized Frequency Upconverter
x TM106 – Rev. 1.1
5.9 Equipment RS-485 (J10), Standard Backward Compatible Interface__________ 5-4
5.10 B/U Switch Interface (J5) ___________________________________________ 5-5
5.11 RF In (J1) _______________________________________________________ 5-6
5.12 Monitor Ports ____________________________________________________ 5-6
5.12.1 IF Monitor Port__________________________________________________ 5-7
5.12.2 RF Monitor Port_________________________________________________ 5-7
5.13 Optional Chain Switching Module ____________________________________ 5-7
5.13.1 (J10) _________________________________________________________ 5-7
5.13.2 (J11) _________________________________________________________ 5-7
5.13.3 (J12 and J13)___________________________________________________ 5-7
5.13.4 (J14) _________________________________________________________ 5-7
5.13.5 (J16 and J17)___________________________________________________ 5-7
5.13.6 (J18) _________________________________________________________ 5-8
5.13.10 (J19) ________________________________________________________ 5-9
Section 6 - Maintenance and Troubleshooting
6.0 Periodic Maintenance_______________________________________________ 6-1
6.1 Failure Analysis ___________________________________________________ 6-1
6.2 DCE/DTE Operation (DIP Switch S3)__________________________________ 6-1
Section 7 - Technical Specifications
7.0 Introduction_______________________________________________________ 7-1
7.1 Output Characteristics______________________________________________ 7-1
7.2 Input Characteristics _______________________________________________ 7-1
7.3 Transfer Characteristics ____________________________________________ 7-1
7.4 Frequency Synthesizer Characteristics ________________________________ 7-3
7.5 Single Side Band Phase Noise _______________________________________ 7-3
7.6 Operator Interface _________________________________________________ 7-3
7.6.1 Converter Settings _______________________________________________ 7-3
7.6.2 Switch Settings __________________________________________________ 7-4
7.6.3 LED Indicators___________________________________________________ 7-4
7.7 Physical Characteristics ____________________________________________ 7-4
7.8 Environmental Characteristics________________________________________ 7-4
To Next Page
Loading...