SFC6400A/SFC1450A Synthesized Frequency Upconverter Table of Contents
TM106 – Rev. 1.1 ix
4.6.2.5 Changing the Logon Password ___________________________________ 4-39
4.6.2.6 Logging Off___________________________________________________ 4-39
4.6.2.7 Changing Your Authentication Password ___________________________ 4-40
4.6.2.8 Changing Your Privacy Password _________________________________ 4-40
4.6.2.9 Converter Ethernet Address _____________________________________ 4-40
4.6.2.10 Converter IP Address __________________________________________ 4-42
4.6.2.11 Server Ethernet Address________________________________________ 4-42
4.6.2.12 Server IP Address_____________________________________________ 4-42
4.6.2.13 Router IP Address_____________________________________________ 4-42
4.6.2.14 IP Address Mask _____________________________________________ 4-42
4.6.2.15 Boot Mode (Optional) __________________________________________ 4-43
4.6.2.16 Community__________________________________________________ 4-43
4.6.2.17 Trap Type and Trap Hosts ______________________________________ 4-43
4.6.2.18 Trace Mode _________________________________________________ 4-43
4.6.2.19 SNMP V1 & 2 Access View _____________________________________ 4-43
4.6.2.20 Key Generation Mode__________________________________________ 4-43
4.6.2.21 Context Engine ID ____________________________________________ 4-45
4.6.3 Connecting the Ethernet Cable and Testing the Link ____________________ 4-46
4.6.3.1 Ping Program _________________________________________________ 4-46
4.6.3.2 SNMP Test___________________________________________________ 4-47
4.6.4 Management Information Base Structure_____________________________ 4-47
4.6.4.1 Simple Network Management Protocol (SNMP) ______________________ 4-47
4.6.4.2 The Management Information Base (MIB) ___________________________ 4-47
Section 5 – Rear Panel Interfaces
5.0 SFC Upconverter Connections _______________________________________ 5-1
5.1 Power___________________________________________________________ 5-1
5.2 10 MHz Ref In (J4) _________________________________________________ 5-1
5.3 10 MHz Ref Out (J3) _______________________________________________ 5-1
5.4 Test/Fault (J7) ____________________________________________________ 5-2
5.5 Operator Serial I/O (J8) _____________________________________________ 5-2
5.6 IF Out (J2) _______________________________________________________ 5-3
5.7 Terminal (J6) _____________________________________________________ 5-3
5.8 Ethernet (J9)______________________________________________________ 5-3
To Next Page
Loading...