Radyne ComStream SFC6400A - Page 141

Appendix C SFC6400A/SFC1450A Synthesized Frequency Upconverter
C-12 TM106 – Rev. 1.1
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"Shows the current prime converter in hot standby. 0 means no converter
is currently in hot standby. This is valid only in automatic backup modes."
::= { radConverterSwitchStatus 12 }
-- --------------------------------------------------------------------------------------------------------------------
-- --------------------------------------------------------------------------------------------------------------------
-- Converter common non-volatile status information.
radConverterCommonControlMode OBJECT-TYPE
SYNTAX INTEGER {
front_panel(1),
terminal(2),
remote(3),
ethernet(4),
}
MAX-ACCESS read-write
STATUS current
DESCRIPTION
""
::= { radConverterCommonNVStatus 1 }
radConverterCommonTerminalBaudRate OBJECT-TYPE
SYNTAX INTEGER {
baud_2400(1),
baud_9600(2),
baud_19200(3)
}
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Selects terminal baud rate."
::= { radConverterCommonNVStatus 2 }
radConverterCommonTerminalEmulation OBJECT-TYPE
SYNTAX INTEGER {
vt100(1),
wyse50(2),
addsvp(3)
}
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Selects terminal emulation."
::= { radConverterCommonNVStatus 3 }
radConverterCommonTerminalEchoMode OBJECT-TYPE
SYNTAX INTEGER {
on(1),
off(2)
}
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Selects terminal echo mode. Not currently in use."
::= { radConverterCommonNVStatus 4 }
radConverterCommonRemoteProtocol OBJECT-TYPE
SYNTAX INTEGER {