User Interfaces SFC6400A/SFC1450A Synthesized Frequency Upconverter
4-14 TM106 – Rev. 1.1
REMOTE PORT:
REMOTE PRTOCOL: {ASCII, RLLP}
Allows the user to set the remote port communication
protocol.
REMOTE ADDR: {32 - 255 RLLP, 1 – 255 ASCII}
Allows the user to set the communication address of the
remote port.
REMOTE BAUD: {2400, 9600, 19200}
Allows the user to set the baud rate for remote port
communication.
ECHO MODE: {OFF, ON}
Allows the user to control whether the input at the
terminal is echoed back. Only valid in Remote ASCII
Mode.
REMOTE LINE: {RS-232, RS-485}
Sets the interface type of the remote port.
HW/FW CONFIG:
FIRMWARE: FW/XXXX - - Version Y.YY
Displays the revision number of the installed M&C
Firmware (where XXXX is the firmware number and Y.YY is
the version).
FW/XXXX - - 19DEC2002
Displays the revision number and release date of the
installed M&C Firmware.
CPLD VERSION: {x.x}
Displays version number of installed CPLD Firmware.
FPGA VERSION: {x.x}
Displays version number of installed FPGA firmware.
HARDWARE:
CONVRTR CONFIG: {STAND ALONE, PRIMARY 1F1, BACKUP 1F1,
PRIMARY 1 - 8 1F8, BACKUP 1F8}
Allows the user to indicate the function of the Converter as
it is connected in the system. The M&C determines this
by reading 4 ID bits through the switch interface (refer to
Section 5.10).
CONVERTER ID: {1 - 11, 15}
Displays a decimal version of the binary ID bits described
above and in Section 5.10. The individual bits are
strapped high or low at the switch. They are decoded as
follows.
To Next Page
Loading...