RaiseTouch User Manual Date:03/03/2020
- 8 / 80 -
www.raise3d.com
: Z axis homing.
: Homing nozzles, heat bed and Z axis.
: Unlocking all motors. This sign is not a warning sign, If the X axis and Y axis are homed, the
extruders cannot be moved manually. Click the button to unlock the motor to remove the extruders.
1.3.2 Filament Loader
1.3.2.1 Automatic Load
Click “Filament Loader” on the left to enter the Filament Loader page, the Automatic Load page will
be displayed by default.
Automatic Load
To Next Page
Loading...
