Ratio Computers iDive Color - DECO STOPS (for Idive Color Tech+ Only)

51
WARNING: This manual DOES NOT replace an adequate diving training !
DECO STOPS (for iDive Color Tech+ only)
The whole dive profile is divided in 3 depth zones.
LEG1: First Zone: from the surface to depth DEPTH1.
LEG2: Second Zone: from DEPTH1 to DEPTH 2.
LEG3: Third Zone: from DEPTH2 to the maximum depth reached during the dive
For every depth zone it is possible to specify which decompression step to use to
calculate the different stops in that zone by the parametres STEP1, STEP2, STEP3.
example: LEG1= STEP:3 / DEPTH:15 - LEG2= STEP:3 / DEPTH:48 - LEG3=STEP:5
With this settings, for depths below 48mt the stops will be spaced out of 5 mt
between them; the stops included between 48 mt and 15 mt will be spaced out of
3 mt while the stops between 15 mt and the surface will be spaced out of 3 mt.
Do you know what?: To force the last stop to a certain depth (eg. 6mt) you can set STEP1=6mt and DEPTH1=6mt
Do you know what?: You can keep pressed the buttons of the iDive Color to change the data more rapidly.
STEP parametres can be modified with step of 1.0mt.
DEPTH parametres can be modified with step of 1.0mt.
Do you know what?:
If you have any doubts on your device’s setting, you can set the company’s parametres from the menu DEFAULT
For iDive Tech+ only
clockwise
counter-
clockwise
Enter
Back
b
C
A
D
DECO
STOPS
clockwise
or
+
Use B and D to select the setting, use C to enter the
setting you want to change.
(Once you selected the setting with C)
Use B and D to change the value of the setting and press
C to conrm the changes.
counter-
clockwise
or
-
Enter
or
Conrm
Back
b
C
A
D
DECO SET
LEG1
STEP: 3
DEPTH: 15