Rauch AXIS H EMC Series - Page 78

Service information
AXIS-H EMC+W
RAUCH Landmaschinenfabrik GmbH D-76547 Sinzheim
Customer service hotline: +49 (0)7221 985 250
E-mail: service@rauch.de
Page 3
of 4
27.10.2014
Chapter 450
The
known quantity
menu may also be
called up directly
2. Application of calibration values (for software update or change of the implement ECU)
(Figures refer to AXIS-H 30.1 EMC with CCI terminal)
In the calibration data menu, the AD values
can be read and transmitted
CAUTION! If weigh cells are replaced,
recalibration is mandatory.
 Transmit the values for calibration
point 1 (empty spreader) and
calibration point 2 (known quantity)
 Confirm the values
The calibration is completed
3. Checking the calibration
(Figures refer to AXIS-H 30.1 EMC with CCI terminal)
Before the test, set the scale to zero while
the hopper is empty