AXIS-H EMC/AXIS-H EMC+W
Machine options >SW 2.05.00
RAUCH Landmaschinenfabrik GmbH D-76547 Sinzheim
Customer service hotline: +49 (0)7221 985 250
E-mail: service@rauch.de
Page
2
of
3
27.10.2014
Chapter 470
Here, the spreader type is changed.
CAUTION! Impact on the control
parameters!
The curve correction may compensate the
suction effect of the spreading discs. At the
AXIS, this suction effect does not occur due
to the design of the spreading disc. The
value remains at 0.
Currently, only actuator type Römheld (
)
is installed in the AXIS. 03 refers to the
number of calibration steps.
If level sensors are retrofitted, this field has
to be checked for activation.
If the spreader is equipped with weigh cells,
these are activated here.
AXIS-H 30.1 EMC => Option: EMC+W
AXIS-H 50.1EMC+W => Series
To Next Page
Loading...
