Rauch AXIS H EMC Series - Using the Fertiliser Chart; Adjusting the Application Rate

AXIS-H EMC/AXIS-H EMC+W
Machine options >SW 2.05.00
RAUCH Landmaschinenfabrik GmbH D-76547 Sinzheim
Customer service hotline: +49 (0)7221 985 250
E-mail: service@rauch.de
Page 3
of 3
27.10.2014
Chapter 470
Input of the spreader serial number
Specification for the
calculation of OPTI-
POINT.
Example:
DIST/LENGTH: CCI, ME > SW4.08.01,
TopCon
DIST/TIME: CCI, JD2600, JD2630,
FM1000, AgriTouch, Tellus Match
FAG: FAG sensor for torque measurement
TC rate buf: Buffering of the target quantity
during EMC measurement, e.g. for N-
sensors