Rauch AXIS H EMC Series - Removing and Mounting Spreading Discs

AXIS-H EMC/AXIS-H EMC+W
Machine options >SW 3.00.00
RAUCH Landmaschinenfabrik GmbH D-76547 Sinzheim
Customer service hotline: +49 (0)7221 985 250
E-mail: service@rauch.de
Page 2
of 4
27.10.2014
Chapter 471
AXIS 30/AXIS 50: Here, the spreader type
is changed.
CAUTION! Impact on the control
parameters!
Curve correction: The curve correction may
compensate the suction effect of the
spreading discs. At the AXIS, this suction
effect does not occur due to the design of
the spreading disc. The value remains at 0.
Actuator type: Currently, only actuator type
Römheld (RH) is installed in the AXIS. 03
refers to the number of calibration steps.
Level sensor: If level sensors are retrofitted,
this field has to be checked for activation.
Weigh cells If the spreader is equipped with
weigh cells, these are activated here.
AXIS-H 30.1 EMC => Option: EMC+W
AXIS-H 50.1EMC+W => Series