Rauch AXIS H EMC Series - Page 87

AXIS-H EMC/AXIS-H EMC+W
Machine options >SW 3.00.00
RAUCH Landmaschinenfabrik GmbH D-76547 Sinzheim
Customer service hotline: +49 (0)7221 985 250
E-mail: service@rauch.de
Page 3
of 4
27.10.2014
Chapter 471
S/N: Input of the spreader serial number
SC Type: Specification
for the calculation of
OPTI-POINT.
Example:
DIST/LENGTH: CCI, ME > SW4.08.01,
TopCon
DIST/TIME: JD2600, JD2630,
Trimble FM1000, YARA AgriTouch, Tellus
Match, AG Leader Integra, Fendt NT01
Observe the manufacturer instructions.
FAG: FAG sensor for torque measurement
Only to be activated if FAG sensors are
installed.
TC rate buf: Buffering of the target quantity
during EMC measurement, e.g. for N
sensors