Instructions for Use RAUMEDIC
MPR2 logO
Manufacturer: zwo-400EN
RAUMEDIC AG, Hermann-Staudinger-Strasse 2, 95233 Helmbrechts, Germany Rev. 9 2020-09-22
Page 28 of 99
4.2 Start screen
Figure 8: Start screen
After the apparatus has been switched on you will be greeted by the Welcome screen. On this screen is
shown the version of installed device software.
In the further description of the device, the software version shown in the graphics may differ from that
installed on your device.
Further, you can in this view
• delete the patient data saved
• define a new patient and
• select the memory mode
If the memory is more than 50 % full, the user now receives the recommendation to delete (clear)
the memory. This recommendation can be ignored, which however has the consequence that the
condition "Memory full" will more than likely be reached instead.
LED Alarm
Delete
Selection
Navigation
Navigation
Confirmation
Display configuration
Software version
Charge condition
LED Power On
On/Off key
Create patient
Select memory mode
Software version
This document is for information only
To Next Page
Loading...