Instructions for Use RAUMEDIC
MPR2 logO
Manufacturer: zwo-400EN
RAUMEDIC AG, Hermann-Staudinger-Strasse 2, 95233 Helmbrechts, Germany Rev. 9 2020-09-22
Page 33 of 99
If you want to accept the selected setting, you can now press OK. If you want to discard your selection,
press the ESC key to return to the previous step.
If the memory mode cannot be changed, the window can be closed by pressing OK. The window can be
closed only, if no pull-down menu is open any more. The memory mode selected remains saved even after
the appliance has been switched off and will appear again as the basic setting when switched on again.
However, the same procedure can be used to change the menu.
"Alarm limits selection" 4.3 Selecting the limiting alarm values
is reached first, provided "New patient" was
selected. Under "Continue measurement" this step is omitted.
4.2.5 No storage
As an alternative to the memory modes Short play (SP) and Long play (LP), from firmware version
2.00.0053 there is an option of selected a third memory mode "No storage".
The advantage of this operating mode is that device can be used in a largely unlimited way, without
a technical alarm "Memory full" being triggered.
This memory mode is recommended, if:
• the user wants to carry out patient monitoring
• does not want to use the device memory function
• is not considering any subsequent data archiving or visualisation on the PC
wishes to carry out measuring as quietly and smoothly as possible without unnecessary technical alarms
(e.g. use at night)
Open Data storage menu. Use the arrow keys to
select the desir
ed memory mode "No storage".
Confirm with OK. The memory mode "No storing"
is indicated in the status line by the symbol
.
Confirm the selected Data storage with OK. If data
is already stored on the device, it must be deleted.
This document is for information only
To Next Page
Loading...