RAUMEDIC MPR2 logO - Setting Date and Time; Setting the Time

Instructions for Use RAUMEDIC

MPR2 logO
Manufacturer: zwo-400EN
RAUMEDIC AG, Hermann-Staudinger-Strasse 2, 95233 Helmbrechts, Germany Rev. 9 2020-09-22
Page 65 of 99
4.6.5 Setting date and time
Changing the date and time requires the automatic creation of a new measurement, which means
that on saving the data on the PC two files are created, one for the time prior to the time setting
and one for the time after. Thus, the data cannot be viewed continuously. On the MPR2, the trend
data from the time prior to the time setting will not be displayed any more. They will remain
saved, however.
Now skip to the set-up screen by pressing the screen selector key several times, if and when required,
and carry out the following steps 1 to 8:
4.6.5.1 Setting the time
Step 1:
Call the Device setup
and press
the Time key.
Step 2:
Press
the Menu key to set the
time.
Step 3:
By pressing the + or - key the hour,
minute and second can be set.
Press the ESC key to return to the
previous step. Complete your
settings by pressing the OK key.
Step 4:
The modified time is displayed.
Th
e modified settings will be
accepted when the windows is
closed by pressing OK.
This document is for information only