Instructions for Use RAUMEDIC
MPR2 logO
Manufacturer: zwo-400EN
RAUMEDIC AG, Hermann-Staudinger-Strasse 2, 95233 Helmbrechts, Germany Rev. 9 2020-09-22
Page 85 of 99
Under the following conditions
• The Datalogger has been switched on and is displayed on the start screen.
• The Datalogger is connected with the PC; the correct USB connection is displayed.
• Datalog software has been started up.
• “Save data on PC2” has been selected (download).
• Press “Start”.
the following message is displayed on the MPR2 whilst downloading data:
The user can close the message at any time by pressing ok, and can continue working, and may also start
a new measurement. In case of an interruption of the data transmission, the user cannot download the data
currently saved on the MPR2 because the PC does not have the information.
In this case, the process has to be repeated.
This document is for information only
To Next Page
Loading...